This my Goldhofer STNL3-Platform trailer "Speedy".
"Speedy" is a very flexible and light platform trailer.
CTRL+ALT+F1/+F2: lower/raise trailer legs
CTRL+ALT+F3/+F4: lock/unlock steering (lock for reverse driving or extending trailer/steering is locked when trailer spawnes)
CTRL+ALT+F5/+F6: extend trailer
CTRL+ALT+F7/+F8: raise/lower liftaxle
CTRL+ALT+F9/+F10: raise/lower trailer ramps
Note: All commads exept ramps are one-press-commands.
Hope you like it :-)
Here's a trailer I made awhile back with a detaching Neck. It can haul some big stuff, has a flexbody deck that bends flat with a heavy load and flexes over bumps. Its not all that finished, but its as finished as its gonna get, lol. I made a video to show how to use it
Ctrl F1 to raise the neck so you can back under and lock on
Ctrl F2 seats the neck on the hitch after you locked on
Ctrl F3 attaches neck to the trailer
Ctrl F4 detaches neck so you can drive it out of the way to load/unload
second upload to the repository another skin for my company rormart this skin is for the Ekeri trailer for 6x2 Scania R560 that kuru made to install it you just put the DDS file in to your ekeri.zip and you done!
A telecopic trailer based on OVB-55-03V(T) model from Nooteboom.
features and commands:
- can extend up to 40m (CTRL+F1/F2)
- manual steering (F7/F8)
- adjutable suspension (CTRL+F3...F8)
- drop sides, to prevent falling loads (CTRL+F9/F10)
- fully working ligths
- avaible in 3 colors: red/yellow/blue
All commands are written on the front left side of the trailer
Ackermann Moving Trailers
Here are my moving trailers for both the Buessing and the Mercedes Moving Vans.
They have managed materials and material-flares, and are useing sections.
They're not loadable... just some nice trailers to pull around.
Pull the trailer next to the load so the rear part is at the right place.
Disconnect the rear part with F11 and pull the front part to the front attachment point.
Use a crane to put the load on, the wood load also has invisible legs so it can be loaded without crane, use F9/10.
The steering strength can be adjusted with F5/6 to fit to the length of the load.
The rear part has manual steering for special situations: F7/8, don't use when the steering is already at maximum angle!
The legs fold in automatically if you pull them up with F1, hold F2 until they fully fold out.
The load will attach on the trailer automatically once it is close enough to the right position.
To unload push F12, but attach it to a crane first and put enough tension until the trailer almost lifts off!
Thanks to Lifter for the hookgroups and triggers and for support with this project!
Thanks to fidoj for his roof part load!
Please do not modify this without my permission,
skins can be added using the skin file system: skins-working
If this system is used properly then no need for my permission for skins.
All content is for use in Rigs of Rods only. Read the copyright file included in the zip!
This is a small map I built for my erectable wind engine.
- Contains all parts of my fully transportable and erectable wind engine. See included manual for button assignments
- A winding road to transport the windmill pieces
- A small train track with tunnels
- Nice looking textures and vegetation (Thanks for all your help DeGa!)