|
|
|
Browsing tag Trailers, found 189 matching files. (8 pages)
|
|
|
6x2 Scania R560 for Ekeri trailer
it has the kyle and sons logo on it
Features:
Openable rear and side doors
Fully contactible submesh
Ties
Credits:
ElNoobio: kyle and sons skin
Korppi (Kuru): All meshes and N/B, some textures, basic skin
Salonen: better skin, ideas
Nexmartin: Refridgerator texture
|
| |
|
|
No Comments yet. Add some here.
|
|
|
This is a complete overhaul of the older arrow board trailer I made all those years ago. It's been completely rebuilt from scratch. It consists of a basic frame, and a basic mesh, so it should be pretty easy on your computer.
Controls:
CTRL+F1/F2 - Raise/Lower legs
CTRL+F3/F4 - Raise/Lower arrow board
CTRL+2 - Left Arrows
CTRL+3 - Right Arrows
CTRL+4 - Center-Out
CTRL+5 - Warn Mode 1
CTRL+6 - Warn Mode 2
Note: While the board and legs may be raised and lowered from the tow vehicle (if it has the forwardcommands tag), you'll have to manually enter the trailer to activate and deactivate the lights. |
| |
| Average Rating: |      | Tags: | Trailers |
Downloads today: 3, all time: 13123 |
|
|
8 Comments, add comments here.
|
 (updated on 30/8/12)
|
Compressor - Atlas Copco XAS 66
UPDATE (by tdev):
- fixed wheels
- added command description
- fixed command visibility
- added contacters
- added GUID for skinning |
| |
| Average Rating: |      | Tags: | Trailers |
Downloads today: 3, all time: 19024 |
|
|
2 Comments, add comments here.
|
 (updated on 29/3/12)
|
This is a Cincinnati Bengals skin zip for the 53Foot greatdane made by Jerald9000.
To install this you need to at least have trailer. You must replace the files within the folder with the ones in the original trailer folder. |
| |
|
|
One Comment, add comments here.
|
|
|
hello, this is my newest trailer for RoR.
I have given him a new mesh that looks a lot better than the old version of the trailer

|
| |
|
|
No Comments yet. Add some here.
|
|
|
This Is A Mod Of Truckian Arrow Board Trailer I Added Wheels To It So You Can Have It In 38.67 Not Sure About Above Or Below Cause I Only Have It For 38.67 Try It Your Self And Let Me Know
CREDITS
Truckian The Orginal Owner
mitcitylover Added wheels
PM me if you have any problems and DO NOT SPAM the comment box thank you. |
| |
|
|
7 Comments, add comments here.
|
|
|
This is my Car dolly. It is straight submesh and very easy on FPS. This is more of a proof of concept as apposed to a full on new modification. You can use almost any vehicle to tow any other vehicle. Since it is submeshed you can scale it to be used on any vehicle rather easily. As of right now this is considered to be in beta. On a side note it is currently impossible to tow any vehicle with contacters. You will have to comment them out or watch them be destroyed by the wheel clamp.
Also feel free to modify and redistribute. Credit is not necessary but it is appreciated.
http://www.rigsofrods.com/threads/85...969#post943969
Commands
F1-F2= Landing gear
F3-F4= Main ramp
F5-F6= Locking mechanism |
| |
|
|
3 Comments, add comments here.
|
 (updated on 14/8/12)
|
Im going to make this simple. Its Called LowPro. Simply stands for low profile. 
Controls
Raise/Lower----CRTL + F1 / F2
Sliding Rear Axle----CRTL + F3 / F4
Fetures
Ajustable Ride Hight
Sliding Axles
Version
Single Axle
Dule Axle
Dule Axle Gooseneck
Tri Axle Gooseneck
Fixed 81Ton Load - Gooseneck
Credits.
Ravidnas1 - All
Support - Lots, Mainly ITOWU
Flares - DJ|Jasper - Thank you so much!!!
Disscuse - Here! |
| |
|
|
22 Comments, add comments here.
|
|
|
Hi,
here is my second upload on the repo:
A 300 ton Heavy Haul LowBoy trailer.
I made the 3d-model some time ago, now I put it into RoR with some overwork.
You can change the color by editing the "300tlb_color.jpg" and the color of the wheels by editing the "300tlb_wheelcolor.jpg".
It has only five invisible wheels, this means it works very smooth even on lower systems (and that is actually the reason why I "cheated" ;-) ).
Use F3/F4 for the (invisible) trailer legs under the first part.
With F1/F2 you can rotate the steering dolly to the left and right. As far as I know this is done via hydraulic in real life. In fact it is just like a semi, but not propulsed.
It is loaded with a big tube.
Have fun driving it (and don't forget to look after the steering dolly ;-) ). |
| |
| Average Rating: |      | Tags: | Trailers |
Downloads today: 3, all time: 29425 |
|
4 Comments, add comments here.
|
 (updated on 1/8/12)
|
This is a mobile home or mobile office depends on how you use it. You can pull it to your location and pull the tires into the body and it will be on the ground like a house. It is a decent amount of weight 22046.23lbs. It is fun to pull around comments are greatly welcomed. This is a 10x40 trailer its not a CAMPER.
made by me
Update 1. made the tongue longer fixed the tires problems added more weight |
| |
|
|
10 Comments, add comments here.
|
 (updated on 31/3/13)
|


Map: La Paz.
This pack is my attempt to capture the Streamline Moderne style popular in the 1930s and 1940s. The vehicles are all fictional, but their performance is realistic. I hope you'll enjoy driving them as much as I have enjoyed making them.

1948 Martin T64S "Custom" Tractor
A very low-slung 6x4 tractor. It has independent front suspension with double wishbones and load sharing rear suspension. The engine is a naturally aspirated 12-cylinder diesel driving through a 7-speed gearbox and locking differentials. Overall length is 29 ft, wheelbase 22 ft from front axle to centre of rear axle group, width 102 in, height 14 ft 9 in to tip of smokestacks. Kerb weight is 20,000 lbs, gross combination weight 80,000 lbs.
Fully loaded, the T64S will reach a top speed of 60 MPH with one of the included trailers. It will accelerate from 0-50 MPH in 1 minute, 0-60 MPH taking approximately 2 minutes.

1948 Martin O40 Tanker
A streamlined tank trailer in fictional "Hexaco" livery. Steel unibody, load sharing suspension. Overall length is 40 ft, wheelbase 28 ft from kingpin to axle group centre, width 102 in, height 10 ft 6 in. Loaded weight is 60,000 lbs.

1948 Martin F45 Flatbed
A simple flatbed trailer with stainless steel load deck and load sharing suspension. The deck is submeshed with the rollon flag and has ties to secure loads. Overall length is 45 ft, wheelbase 36 ft from kingpin to axle group centre, width 102 in, deck height 59 in, overall height 79 in to top of bulkhead. Kerb weight is 12,500 lbs, rated load 47,500 lbs.

1948 Martin V59 "Streamliner" Dry Van
A very large and somewhat impractical dry van. It has a streamlined stainless steel unibody and load sharing suspension. Overall length is 59 ft, wheelbase 47 ft from kingpin to axle group centre, width 102 in, height 14 ft 9 in. Loaded weight is 60,000 lbs.
Notes
These have only been tested in Rigs of Rods version 0.38.67.
The wheels have 40 nodes each, and the meshes were made in Sketchup. Don't expect these to be FPS-friendly.
The trailers are roll coupled via the system used by Lenni and Badboy for trailer steering. The centre of gravity and suspension are tuned accordingly; the trailers may topple easily on trucks that lack these nodes.
To minimise rolling resistance, the wheels are pushing the limits of the beam engine. They tend to oscillate when stationary. Caution is advised when stopping or parking on slopes as they may creep.
The trailers have very low drag. The T64S will not pull most other trailers at high speed.
Credits
CGTextures (restrictions apply, see below)
tiredoldwhiteman
DieselPower24
khadner
bf449
flyer3849
JensLynIV
Licence
CGTextures does not allow redistribution of its textures under open source licences. You must remove/replace their texture before releasing modifications of this truck. All other assets used are available for modding. See the readme for specific file information and licensing details.
Forum thread |
| |
| Average Rating: |      | Tags: | HighQuality, Tanker, Flatbed, Box body, Trailers, 6x4, Semi, Transportation, Heavy Machinery, Land Vehicles |
Downloads today: 20, all time: 8233 |
|
19 Comments, add comments here.
|
|
|
this is another skin for the great dane that will be replacing ror airforce
not much time put into this 1
i have permission from jerald9000
pm and ill make u a trailer skin |
| |
|
|
No Comments yet. Add some here.
|
|
|
RISK 42m² 5th wheel camping trailer
coco, flares.
buttlmao beta testing.
lifter beta testing.
and other beta testers.
F1-F2 F3-F4 front legs
ctrl+F1-ctrl+F2 back leg
its full contactable submesh
all parts made by me, if you want to use any part of this drop me a line maybe i could trim the model for you or give you a single piece in 3ds/blender file. |
| |
| Tags: | Trailers |
Downloads today: 1, all time: 6115 |
|
No Comments yet. Add some here.
|
 (updated on 1/9/12)
|
This is the Mercedes Benz Actros 8x8 pack.
This package includes 8 versions:
- version with no upper part
- ampliroll
- cartransporter (+trailer)
- dumper
- log truck (+trailer NEW!)
- box-truck(+trailer NEW!)
- flatbed (+trailer NEW!)
- trail-truck
It is version 1.1b in english.
Click here for discusing!
Please ask before publishing modifications, except skinzip-skins!
Author: Murkas
Special thanks to
Raydan
Creak
trucker2012
for beta-testing |
| |
|
|
| | on 2/9/12 1821 downloads | This is a ADAC (Algemeiner Deutscher Auto Club ~ German automobile club) - skin for the Actros 8x8 (Cartransporter (+trailer) ; box-truck (+trailer)).
It works with the english and the german pack! v1.1b needed!
[read more] |
|
13 Comments, add comments here.
|
|
|
ACME ribbed trailer. Used for hauling common items, such as anvils, artificial rocks, earthquake pills, Indestructo Steel Balls, jet propelled pogo sticks, and rocket sleds. This one is twice as heavy as the original one, because it is full. |
| |
| Tags: | Trailers |
Downloads today: 0, all time: 7514 |
|
No Comments yet. Add some here.
|
|
|
A standard 45 foot box trailer, as seen behind semis all over the United States. Weathered; decently easy to reskin. |
| |
| Tags: | Trailers |
Downloads today: 0, all time: 4307 |
|
|
No Comments yet. Add some here.
|
|
|
A standard 45 foot box trailer, as seen behind semis all over the United States. Weathered; decently easy to reskin. New version includes contactable submesh by tommylommykins, and fixed rims. (well, they work in North Saint Helens now, but they stopped working in Flatmap. :| ) |
| |
|
|
|
One Comment, add comments here.
|
|
|
This is jerald9000's 53-foot Great Dane trailer, reskinned into the livery of my new trucking company, Dreamland Trucking. The blank area in the center of the sides of the trailers can be skinned to your liking. It should not overwrite the original trailer.
Original trailer: jerald9000
Reskin: burbdetdrive
Here's Dreamland Trucking's thread: Dreamland-Trucking-(WE-RE-HIRING!)
|
| |
|
|
No Comments yet. Add some here.
|
|
|
A skin for the Tanker and T600. Based off a tiny Ohio gas station chain. Picctured is the chardon ohio tank out side of the chardon oil gas station.
"CREDITS" Truck- Box5Diesel & HemiBoy95
Trailer- Trevor
Skins- Me |
| |
| Tags: | T600, Kenworth, CAT, Skins, Tanker, Trailers, Loads, Heavy Duty, Transportation, Street, Land Vehicles |
Downloads today: 4, all time: 4582 |
|
One Comment, add comments here.
|
|
|
mesh by secondking
textures by secondking
suspension by lifter
flares by coco
BigDaddy1d beta testing
to lift the trailers hock point use CTRL+f1 and CTRL+f2 |
| |
| Tags: | Trailers |
Downloads today: 0, all time: 9535 |
|
No Comments yet. Add some here.
|
|
|
A logtrailer that is actually capable of hauling logs arround.
It comes with 3 logs of different weight and size.
The logs were made by Asperion and I have premission to release them with this pack (I've only made minor adjustments to it).
This pack comes with two versions:
High FPS with ordinary wheels
High Detail with meshwheels.
I'm aware of the fact that it spawns of-pad.
Just spawn a log after you spawn the trailer and you should be fine.
Thanks to DennisW for helping me mess arround with the shock values. |
| |
| Average Rating: |      | Tags: | Trailers |
Downloads today: 3, all time: 17177 |
|
One Comment, add comments here.
|
|
|
I made another skin as promised. 
it is a billboard of Starling Island,
you can put it behind the minibus. I would do more if you like them 
|
| |
|
|
One Comment, add comments here.
|
|