Repository : g25-g27.zip

g25-g27.zip (3 KB)
uploaded: on 18/2/11, last modified: on 19/2/11 by theneomaster (view files by author)

made for RoR 0.38

This is a keymap for the Logitech G25 or G27 wheel. It has everything set up for vehicle use, including the push-down reverse gear, the clutch+shifter and the ranges for trucks with more than 6 gears. You must set up the force-feedback yourself.

When first selecting a truck, you may need to push and release each pedal to make them work properly, sometimes they are on 50%. Also, you must have combined pedals OFF. You can do this in the Logitech profiler or via Game Controllers in Control Panel.

Ranges are the four black round buttons on the top of the shifter, the bottom one is for low range, the two middle ones are both for mid range and the top one is for high range. Your gearbox must be in "Fully Manual : Stick shift with ranges" for ranges to work. Your shifter also must be in N to switch ranges.

This MAY work with other Logitech wheels but it's untested and I offer absolutely no promises.

DISCLAIMER : This will not use any controls you currently have set. This is an entirely different button/axis configuration.

INSTALLATION :

0.37 / 0.38.12 and earlier :
1 : Download the ZIP, and extract it to My Documents/Rigs of Rods/config
2 : Open the RoR Configurator, go to Controls, Bindings, and Import Keymap. Browse to My Documents/Rigs of Rods/config and select the g27-g25.map.
3 : Save and Play!

0.38.13 and later, as long as the controls configurator is removed from the configurator :
WARNING : If you do not back up input.map, you will permanently lose all of your current set controls!
1 : Browse to My Documents/Rigs of Rods/config and back up input.map to your documents.
2 : Download the ZIP, and extract it and rename g25-g27.map to input.map
3 : Copy it to My Documents/Rigs of Rods/config and overwrite the current input.map
4 : Play RoR!

When the controls configurator is back, just follow the steps for 0.37 / 0.38.12 and earlier.

__________________________________________________ __________________________________________________ _____________________

UNINSTALLATION :

0.37 / 0.38.12 and earlier :
1 : Open the configurator, go to Controls, Bindings and Import Keymap.
2 : Browse to My Documents/Rigs of Rods/config and select input.map
3 : Save and Play!

0.38.13 and later, as long as the controls configurator is removed from the configurator :
1 : Copy input.map from where you backed it up (didn't? too bad, you were warned) and copy it to My Documents/Rigs of Rods/config and overwrite the current input.map
2 : Play RoR!

When the controls configurator is back, just follow the steps for 0.37 / 0.38.12 and earlier.

Average Rating: