This is a simple Bridge Load i doodled in Sketchup in about 20mins. So dont expect a perfect mesh.
It has four ropables ontop so you can lift it.
Expect it to swing around a bit, since the weight is added at the outer nodes.
It should weigh around 30 tons.
If you like it, i might make more loads in the future.
|Basic File Info:
State: active (2)
1: ok, no problems found
>> add Mod for this file <<
All Comments (10):
You need to login to leave comments
|aurelien (on 10/5/11) ||Bonjour jadore tes objet si tu veu bien je veu bien que ten refase :)|
|TampaPowers (on 5/2/11) ||[mod author]||Over 1000 downloads wow!|
|i b luke (on 25/1/11) ||nice. i was wondering how to put sketup files into ror. ican't figure it out. also, how do you put ropables on it?|
|OfficerAndrew (on 25/1/11) ||Very nice! I'd say this is the top of the heavy loads because this prolly would take me 40 minutes!|
|icantswimj (on 25/1/11) ||awsome! Its kinda hard to lift it though lol!|
|Timmer (on 23/1/11) ||a very nice load ,Goo Job|
|mdvonte (on 23/1/11) ||nice... it fits perfectly on the stepdeck flat bed... keep up the good work |
|mike-E-boy (on 23/1/11) ||Great work! Would be nice to hava a bridge with contactable road!|
|csxgp38-2 (on 23/1/11) ||Nice, better than anything I could do in sketchup in 50 mins :p Will be a challenge to lift. Is the deck contactable, so you can drive on it as a bridge?|
|rapter (on 23/1/11) ||oh man thats awsome 20 min? no way|